[. . . ] Connect Your Smart Switch Installation Guide NETGEAR Smart Switch™ GS728TP, GS728TPP, GS752TP These instructions assume you are using DHCP in your network. If you are using static IP addressing in your network, configure the switch IP address before connecting the switch to your network. [. . . ] In most cases, computers should be configured to obtain an IP address through DHCP. If your network uses static IP addresses, be sure that the switch and computer are configured with valid IP addresses. Technical Support After installing your device, locate the serial number on the label of your product and use it to register your product at https://my. You must register your product before you can use NETGEAR telephone support. NETGEAR recommends registering your product through the NETGEAR website. The Smart Control Center Utility finds the switch and displays its MAC address, IP address, and model number. If you cannot configure your switch, verify that the cable connections are secure and that the IP address configuration of the computer is in the same subnet as the switch, and click the Discover button. If there are multiple switches in your network, be sure to select the one you want to configure. For additional information about setting up, configuring, and using your smart switch, see the software administration manual. NETGEAR recommends that you use only the official NETGEAR support resources. [. . . ] NETGEAR, the NETGEAR logo, and Connect with Innovation are trademarks and/or registered trademarks of NETGEAR, Inc. Other brand and product names are registered trademarks or trademarks of their respective holders. [. . . ]